BBASICGO



BBASICGO

     Compiles, prepares, and executes an HP Business BASIC/V program in
Compatibility Mode. HP Business BASIC/V is not part of the 900
Series HP 3000 Computer System Fundamental Operating Software and
must be purchased separately. (CM)

SYNTAX

     BBASICGO infile[,listfile]

PARAMETERS

infile              Actual file designator of the BSAVE file containing
the BBASIC program to be compiled. Formal file
designator is BBCIN.

listfile Actual file designator of the file to which the
program listing is written. This can be any ASCII
output file. Formal file designator is BBCLIST.
Default is $STDLIST.

NOTE

The formal file designators used in this command (BBCIN and BBCLIST)
cannot be backreferenced as actual file designators in the command
parameter list. Refer to the "IMPLICIT FILE COMMANDS FOR SUBSYSTEMS"
discussion of the MPE/iX FILE command.

USE

This command may be issued from a session, job, or program. It may not
be used in BREAK. Pressing [Break] suspends the execution of this
command. Entering RESUME continues the execution.

OPERATION

     This command compiles, prepares, and executes a program from
a BSAVE file created by the BBASIC interpreter. This
enables the program to run faster than it would if it were
executed by the interpreter.

You may create a BSAVE program file within the BBASIC
interpreter after it is saved by using the BBASIC
interpreter command >SAVE filename. The program then can be
compiled, prepared, and executed with the BBASICGO command.

EXAMPLE(S)

     To compile, prepare, and execute the BBASIC program MYPROG
and send the listing to the disk file LISTFL, enter

BBASICGO MYPROG,LISTFL ** Compiles, prepares, **
** and runs the **
** program MYPROG. **

ADDITIONAL INFORMATION

Commands:   BBASIC, BBASICOMP, BBASICPREP

Manuals :   HP Business BASIC/XL Reference Manual (32715-60001)
            MPE Segmenter Reference Manual (32650-60026)