FORTGO



FORTGO

     Compiles, prepares, and executes a Compatibility Mode
FORTRAN 66/V program. FORTRAN 66/V is not part of the 900
Series HP 3000 Computer System Fundamental Operating
Software and must be purchased separately. (CM)

SYNTAX

     FORTGO [textfile][,[listfile][,[masterfile][,[newfile]]]]
[;INFO=quotedstring]

PARAMETERS

textfile            Actual file designator of the input file from which
the source program is read. This can be any ASCII
input file. The formal file designator is FTNTEXT.
Default is $STDIN.

listfile Actual file designator of the file to which the
program listing is written. This can be any ASCII
output file. The formal file designator is FTNLIST.
Default is $STDLIST.

masterfile Actual file designator of the master file with which
textfile is merged to produce a composite source.
This can be any ASCII input file. The formal file
designator is FTNMAST. Default is that the file is
not read; input is read from textfile, or from
$STDIN if textfile is not specified.

newfile Actual file designator of the file resulting from
merging of textfile and masterfile. This can be any
ASCII output file. The formal file designator is
FTNNEW. Default is that the file is not written.

quotedstring A sequence of characters between two single
quotation marks (apostrophes) or between two double
quotation marks. You may use the delimiter as part
of the string so long as the delimiter appears
twice. Any occurrence of two single quotation marks
in a row, or two double quotes in a row, is
considered part of the string, and, therefore, not
the terminating delimiter. INFO=quotedstring is used
to pass initial compiler options to a program.

NOTE

The formal file designators used in this command (FTNTEXT,
FTNLIST,FTNMAST and FTNNEW) cannot be backreferenced as actual file
designators in the command parameter list. For further information,
refer to the "IMPLICIT FILE COMMANDS FOR SUBSYSTEMS" discussion of the
MPE/iX FILE command.

OPERATION

     The FORTGO command compiles, prepares, and executes a
Compatibility Mode FORTRAN 66/V program. If you do not
specify a source file, MPE/iX expects input from your
standard input device. If you do not specify listfile,
MPE/iX writes the listing to your standard output device.

The USL file created during the compilation is a system-
defined temporary file $OLDPASS, which is passed directly to
the MPE Segmenter, and cannot be accessed.

This command may be issued from a session, job, or program. It may
not be used in BREAK. Pressing [Break] suspends the execution of
this command. Entering RESUME continues the execution.

EXAMPLE(S)

     To compile, prepare, and execute an FORTRAN 66/V program
entered from the disk file SOURCE and transmit the resulting
program listing to the disk file LISTFL, enter

FORTGO SOURCE,LISTFL

To enter your source input from a device other than your
standard input device, and/or direct the listing to a device
other than your standard list device, simply name the input
and listing files as command parameters. In the example
below, the source listing is read from magnetic tape,
formally identified by the file name MTAPE. Output is sent
to the printer, identified by the file name PRTR.

FILE MTAPE;DEV=TAPE
FILE PRTR;DEV=FASTLP

MTAPE and PRTR are then backreferenced in the FORTGO
command, as shown here

FORTGO *MTAPE,*PRTR

ADDITIONAL INFORMATION

Commands:   FORTPREP, FORTRAN

Manuals :   HP FORTRAN 77/iX Reference (31501-90010)
            MPE Segmenter Reference Manual (32650-60026)